BS 6782-17-2001 涂料用粘合剂.水稀释的粘合剂的MEQ值的测定
时间:2024-05-12 11:20:39 来源: 标准资料网 作者：标准资料网 阅读：9260
【英文标准名称】:Bindersforpaints-DeterminationofMEQvalueofwater-dilutablebinders
【原文标准名称】:涂料用粘合剂.水稀释的粘合剂的MEQ值的测定
【标准号】:BS6782-17-2001
【标准状态】:现行
【国别】:英国
【发布日期】:2001-03-15
【实施或试行日期】:2001-03-15
【发布单位】:英国标准学会(BSI)
【起草单位】:BSI
【标准类型】:()
【标准水平】:()
【中文主题词】:酸;覆层;强碱;粘合剂;容量分析;溶质;非挥发物测定;涂料
【英文主题词】:coatingmaterials;testing;waterdilutability;solvents;acidvalue;definitions;paints;artificialresins;rawmaterials;titrimetry;aminevalue;definition;bindingagents
【摘要】:
【中国标准分类号】:G52
【国际标准分类号】:87_060_20;87_040
【页数】:12P;A4
【正文语种】:英语
【英文标准名称】:NomenclatureforGlassBulbsIntendedforUsewithElectricLamps
【原文标准名称】:电灯玻璃灯泡名词术语
【标准号】:ANSIC79.1-1971
【标准状态】:作废
【国别】:
【发布日期】:
【实施或试行日期】:
【发布单位】:美国国家标准学会(US-ANSI)
【起草单位】:
【标准类型】:()
【标准水平】:()
【中文主题词】:
【英文主题词】:
【摘要】:
【中国标准分类号】:
【国际标准分类号】:
【页数】:
【正文语种】:
Product Code:SAE AMS4163
Title:Aluminum Alloy, Extrusions 6.3Cu - 0.30Mn - 0.18Zr - 0.10V - 0.06Ti (2219-T3511) Solution Heat Treated, Stress-Relieved by Stretching, and Straightened
Issuing Committee:Ams D Nonferrous Alloys Committee
Scope: This specification covers an aluminum alloy in the form of extruded bars, rods, wire, profiles, and tubing.These extrusions have been used typically for structural parts requiring high strength up to 500 degrees F (260 degrees C) after proper precipitation heat treatment, but usage is not limited to such applications and which may require welding during fabrication.Certain design and fabricating procedures may cause material in the specified condition to be susceptible to stress-corrosion cracking; SAE ARP 823 recommends practices to minimize such conditions.
Rationale: This specification covers an aluminum alloy in the form of extruded bars, rods, wire, profiles, and tubing.These extrusions have been used typically for structural parts requiring high strength up to 500 degrees F (260 degrees C) after proper precipitation heat treatment, but usage is not limited to such applications and which may require welding during fabrication.Certain design and fabricating procedures may cause material in the specified condition to be susceptible to stress-corrosion cracking; SAE ARP 823 recommends practices to minimize such conditions.